Omron F3SG-RA, User Manual

Page: 221 / 268

197
F3SG-R
User’s Manual
Ch
apt
e
r
5
Wir
ing
Ex
amples
(F3
S
G-
RA
Series
)
Input/Output Circuit and Applications
E
5-2-2-2. F3SG-RA with Y-Joint Plug/Socket Connector in Standard Muting
Mode/Exit-Only Muting Mode using PNP outputs
The following is the example of External Device Monitoring disabled, Auto Reset mode, PNP output
and External Test in 24 V Active.
[DIP Switch settings] *5
 : Indicates a switch position.
Configure functions with the DIP Switches before wiring.
[Wiring Example]
Function DIP-SW1 DIP-SW2
Receiver
EDM Disabled (factory default setting)
Auto Reset (factory default setting)
PNP (factory default setting)
Emitter External Test: 24 V Active (factory default setting)
㻞 㻻㻺 㻞 㻻㻺
㻟 㻻㻺 㻟 㻻㻺
㻠 㻻㻺 㻠 㻻㻺
㻣 㻻㻺 㻣 㻻㻺
㻠 㻻㻺
0 VDC: Blue RESET: Yellow*1 MUTE A: Gray MUTE B: Pink AUX: Red OSSD1: Black OSSD2: White 24 VDC: Brown
+24V DC
0V
IN1 IN1 IN2
Safety
Controller *3 *4
F39-JG B-L
F39-JG A-D
F39-GCNY2
S1
*2
Power supply
S1: Lockout/Interlock Reset Switch,
Override Switch or Override Cancel Switch
ML: Muting Lamp
Unblocked
Blocked
MUTE A
MUTE B
OSSD
Beam state
PLC *6
*1. Also used as EDM input line.
*2. Make sure to connect an override cancel switch to the
Reset line when using the override function. Otherwise
the override state may not be released by the override
cancel switch, resulting in serious injury.
*3. Refer to 5-4. Connectable Safety Control Units for
more information.
*4. The safety controller and the F3SG-R must share the
power supply or be connected to the common terminal
of the power supply.
*5. The functions are configurable with DIP Switch. Refer
to Chapter 3 Setting with DIP Switch for more
information on setting the functions by the DIP Switch.
*6. When connecting to the PLC, the output mode must be
changed with the Configuration Tool according to your
application.