![background image](http://html1.mh-extra.com/html/omron/cpm2c-s100c/cpm2c-s100c_operation-manual_742520198.webp)
176
Programming Console Operations
Section 8-2
5.
The search will continue until an END instruction or the end of Program
Memory is reached. In this case, an END instruction was reached at ad-
dress 397.
8-2-11 Bit Operand Search
This operation is used to find occurrences of the specified operand bit in the
program and is possible in any mode.
The ON/OFF status of any displayed bit will be shown if the PC is in RUN or
MONITOR mode.
1,2,3...
1.
Press the CLR Key to bring up the initial display.
2.
Input the operand address. It is not necessary to input leading zeroes.
3.
Press the SRCH Key to begin the search.
4.
Press the SRCH Key to search for the next occurrence of the operand bit.
5.
The search will continue until an END instruction or the end of Program
Memory is reached. In this case, an END instruction was reached.
8-2-12 Inserting and Deleting Instructions
This operation is used to insert or delete instructions from the program. It is
possible in PROGRAM mode only.
SRCH
00397SRCH
END (001)00.4KW
Indicates the address
of END instruction.
Indicates the amount used by the user
program in units of 0.1 Kwords.
RUN
MONITOR
PROGRAM
OK
OK
OK
SHIFT
CONT
#
F
5
00000CONT SRCH
LD
00005
SRCH
00123CONT SRCH
LD
00005
SRCH
00255CONT SRCH
AND NOT
00005
SRCH
00397CONT SRCH
END (001)00.4KW
Indicates the address
of END instruction.
Indicates the amount used by the user
program in units of 0.1 Kwords.
RUN
MONITOR
PROGRAM
No
No
OK
Summary of Contents for CPM2C-S100C
