Omron CPM2C-S100C, Operation Manual, Page: 207 / 269

185
Programming Console Operations Section 8-2
(Input the new value and press the WRITE Key to write the changes in
memory if no more changes will be made.)
4. Input the new value for the middle word on the display and press the CHG
Key if the rightmost word will be changed. Input the new value and press
the WRITE Key to write the changes in memory if the rightmost word will
not be changed. (In this case, it will not.)
Note If the CLR Key is pressed before the WRITE Key, the operation will be can-
celled and the 3-word monitor display will return without any changes in data
memory.
8-2-21 Changing Timer, Counter SV
There are two operations that can be used to change the SV of a timer or
counter. They are possible in MONITOR or PROGRAM mode only. In MONI-
TOR mode, the SV can be changed while the program is being executed.
The timer or counter SV can be changed either by inputting a new value or by
incrementing or decrementing the current SV.
Inputting a New SV
Constant This operation can be used to input a new SV constant, as well as to change
an SV from a constant to a word address designation and vice versa. The fol-
lowing examples show how to input a new SV constant and how to change the
SV from a constant to an address.
1,2,3... 1. Press the CLR Key to bring up the initial display.
2. Display the desired timer or counter.
3. Press the Down Arrow Key and then the CHG Key.
4. At this point a new SV constant can be input or the SV constant can be
changed to a word address designation
a) To input a new SV constant, input the constant and press the WRITE
Key.
b) To change to a word address designation, input the word address and
press the WRITE Key.
B
1 CHG
D0002 3CH CHG?
0001 4567 89AB
C
2
D
3
E
4
WRITE
, ,,
!" &')*
RUN MONITOR PROGRAM
No OK OK
TIM
B
1
SRCH
00201SRCH
TIM 001
↓
CHG
00201DATA?
T001 #0134 #????
B
1
C
2
E
4
WRITE
00201 TIM DATA
#0124
SHIFT
CH
*
DM
AR
HR
B
1
A
0 WRITE
00201 TIM DATA
HR 10