Omron CPM2C-S100C, Operation Manual, Page: 220 / 269

198
Programming Example Section 8-3
2. Input the normally closed AND condition T001.
(It isn’t necessary to input leading zeroes.)
3. Input the OUT instruction IR 01000.
(It isn’t necessary to input leading zeroes.)
(6) Inputting the END(001)
Instruction Input END(01). (The display shows three digits in the function code, but only
the last two digits are input for CPM2C-S PCs.)
8-3-4 Checking the Program
Check the program syntax in PROGRAM mode to make sure that the program
has been input correctly.
1,2,3... 1. Press the CLR Key to bring up the initial display.
2. Press the SRCH Key. An input prompt will appear requesting the desired
check level.
3. Input the desired check level (0, 1, or 2). The program check will begin
when the check level is input, and the first error found will be displayed. If
no errors are found, the following display will appear.
Note Refer to 9-4 Programming Errors for details on check levels and the
programming errors that may be displayed during a program check.
4. Press the SRCH Key to continue the search. The next error will be dis-
played. Continue pressing the SRCH Key to continue the search.
The search will continue until an END(01) instruction or the end of Program
Memory is reached.
AND
NOT
TIM
B
1
15
AND NOT TIM 001
WRITE
16READ
NOP (000)
OUT
B
1
A
0
A
0
A
0
16
OUT 01000
WRITE
17READ
NOP (000)
FUN
17
FUN (0??)
A
0
B
1
17
END (001)
WRITE
18READ
NOP (000)
CLR
SRCH
PROG CHK
CHK LBL (0-2)?
A
0
17PROG CHK
END (001)00.1KW