![background image](http://html1.mh-extra.com/html/omron/cpm2c-s100c/cpm2c-s100c_operation-manual_742520183.webp)
161
Using a Programming Console
Section 8-1
ed while a time-consuming operation (such as a program check) is being
performed.
Panel Installation
The C200H-PRO27-E Programming Console can be installed in a control
panel as shown in the following diagram. (The C200H-ATT01 Mounting
Bracket is sold separately.)
Allow at least 80 mm for the cable connector above the Programming Con-
sole.
8-1-2
Compatible Programming Consoles
There are 3 Programming Consoles that can be used with the CPM2C-S: The
CQM1H-PRO01-E, CQM1-PRO01-E and the C200H-PRO27-E. The key func-
tions for these Programming Consoles are identical.
Press and hold the Shift Key to input a letter shown in the upper-left corner of
the key or the upper function of a key that has two functions. For example, the
CQM1-PRO01-E’s AR/HR Key can specify either the AR or HR Area; press
and release the Shift Key and then press the AR/HR Key to specify the AR
Area.
186
+1.1
−
0
92
+0.8
−
0
Mounting Bracket
Two screws
Panel thickness: 1.0 to 3.2 mm
Mounting hole dimensions
(DIN43700 standards)
About 70 mm is required.
At least 80 mm is required.
Either connector may
be used.
37
15
Summary of Contents for CPM2C-S100C
