![background image](http://html1.mh-extra.com/html/omron/c200hw-srm21-v1-cs1w-srm21/c200hw-srm21-v1-cs1w-srm21_operation-manual_742333083.webp)
62
Connector Installation (Special Flat Cable Only)
Section 3-2
10. Check the assembled connector from the side and make sure that the
locks are completely engaged, as shown in the following diagram.
3-2-3
Connector Terminator
When the system has a main line that needs to be distinguished from the
branch lines, a Connector Terminator is connected at the end of main line
opposite the Master. If the main line does not need to be distinguished from
the branch lines, a Connector Terminator is connected the end of the commu-
nications cable farthest from the Master.
Connector Components
The Connector Terminator has two components: Cover 1 and the contact
block. The following diagram shows Cover 1.
The following diagram shows the contact block.
Installation Procedure
Use the following procedure to attach a Connector Terminator to the commu-
nications cable.
The following procedure is an example to connect a Connector Terminator to
the main cable. The same procedure will apply even if the main line does not
need to be distinguished from the branch lines.
Before Compression
After Compression
Locks
Cover number
Hinge
Surface number
Cable stop
Contacts