Oce VarioLink 2222c, User Manual

Page: 169 / 318

Send (Public, Personal, or Group User Box)
7
7-54 VL3622c/VL2822c/VL2222c
7.6
ECM OFF
The Error Correction Mode (ECM) is turned off when sending data. ECM is an error correction mode defined
by ITU-T (International Telecommunication Union - Telecommunication Standardization Sector). Fax ma-
chines equipped with the ECM feature communicate with each other, confirming that the data sent is free of
errors. Thus, communication can be made free from disturbances due to line noises, etc. If noises frequently
occur, it may take a slightly long time to complete a communication compared with ECM OFF. After sending
has been ended, this machine automatically returns to ECM ON.
Reference
- This machine sends faxes in ECM ON unless ECM OFF is specified.
- This function cannot be used together with the following functions.
– Polling RX
– Polling TX
– V.34 OFF
– Bulletin board registration
– Bulletin board polling reception
V.34 OFF
V34 is a communication mode used for super G3 fax communication. When the remote machine or this ma-
chine is connected to a telephone line via PBX, however, you may not establish a communication in the super
G3 mode depending on telephone line conditions. In this case, it is recommended that you turn V34 off to
send data. After sending has been completed, this machine automatically returns to the V34 mode.
Reference
- This function cannot be used together with the following functions.
– Polling RX
– Polling TX
– Bulletin board registration
– Bulletin board polling reception
– ECM OFF
Check Dest. & Send
The specified fax number is compared with the remote fax number (CSI) and data is sent only when those
fax numbers match. If they do not match, the communication will fail; therefore preventing a sending error.
Reference
- To use the Check Dest. & Send, you must register the local fax number in the remote machine in ad-
vance.
Select Line
You can specify [Line 1] or [Line 2] for sending data when two optional Fax Kit are installed. Specify the line
used for transmission. If you select [Not Set], either Line 1 or Line 2 whichever is not busy is used for trans-
mission. If both lines are idle, Line 1 is used first.
Reference
- You cannot specify a line when [Line 2 Setting] is set to [RX Only] in [Multi Line Settings]. For details on
the Multi Line Usage function, refer to the [User's Guide Network Scan/Fax/Network Fax Operations].
- To use two lines as external and extension lines, be sure to specify the line to be used. If you select [Not
Set], a sending failure may occur.