Oce 9400-II, User Manual

Page: 64 / 167

64 Océ 9400-II User Manual
Adjusting the leading/trailing edge
Increasing the copy length to accommodate for a filing strip is possible by
selecting a positive leading/trailing edge.
If you don’t want the filing strip to show on the copy, it is possible to remove
it, by selecting a negative leading or trailing edge. The adjustment steps are
indicated on the operating panel, expressed in millimetres or inches.
▼ ▼ ▼ ▼
Adjusting the leading/trailing edge
1
Press the ‘edge’ button to toggle between leading and trailing edge.
2
Press the ‘up’ or ‘down’ button to select the required leading/trailing edge
value. The length of the currently selected edge is shown in the display.
If you make adjustments using this button the indications above the button are
flashing. If the adjustment differs from the default setting, the indication
remains on. You confirm the setting by pressing the zoom, edge, cut, media or
start button.
Attention:
Be aware that decreasing the edges too much may result in a loss
of information.
The behaviour of adjusting the leading/trailing edge is different, depending on
using roll feed or manual feed (see ‘Leading/trailing edge when copying on
rolls of paper’ on page 65) and ‘Leading/trailing edge when copying on sheet
of paper’ on page 66).