Oce 9400-II, User Manual

Page: 59 / 167

Copy jobs 59
Activating/de-activating the rewind function
Note:
The default setting is configured by the Océ service technician.
If you have a very precious original, it may be useful not to return the original
back to the operator. In this case you can use the ‘start’ button to activate a
deviation from the default settings.
Three defaults settings are possible:
1
the original is always rewinded after scanning.
2
the original is rewinded after scanning, unless you tell the scanner to leave the
original at the back of the scanner.
3
the original is not rewinded, unless you tell the scanner to feed the original
back to the front of the scanner.
If you feed an original, and the rewind function is not active, you have to press
the ‘start’ button only for the first original. The next originals will be fed
automatically (stream feed). Make sure you have made new settings before
feeding the original.
▼ ▼ ▼ ▼
De-activating the rewind function (in situation 3)
1
Insert the original face down and right aligned.
2
Make the required settings.
3
Press the ‘start’ button.
4
During scanning press the ‘start’ button again. The indication light above the
start button is flashing.
5
The original will be hold at the back of the scanner.
▼
▼ ▼
▼
Activating the rewind function (in situation 2)
1
Insert the original face down and right aligned.
2
Make the required settings.
3
Press the ‘start’ button.
4
During scanning press the ‘start’ button again. The indication light above the
start button is flashing.
5
The original will be rewinded after scanning.
The settings will return to default,
■
if no original is fed,
■
an error has occurred,
■
the correction button is pressed,
■
the panel time out has exceeded.