Oce 9400-II, User Manual

Page: 63 / 167

Copy jobs 63
Copying using synchro or standard cut
In synchro cut mode, the copy is cut at the length of the original, taking into
account the zoom factor and the leading/trailing edge setting. Synchro cut
mode is selected by default.
In standard cut mode, the copy is cut at a standard format (portrait). You select
the width of the standard format with the ‘up’ or ‘down’ button.
Example: selecting 36 inches, means selecting a format of 36 inches width and
a corresponding 48 inches length. Independently of the roll width, the material
is cut at a length of 48 inches.
Note:
Depending on the used range of ISO, ANSI or ARCH you get the paper
sizes mentioned in the appropriate column (see ‘Order of standard sizes for
using standard cut’ on page 140).
If you make adjustments in standard mode using the cut button, the indication
‘standard’ above the button is flashing. After confirming the standard
selection, the indication remains on. You confirm the setting by pressing the
zoom, edge, cut, media or start button.
When choosing standard cut, the system always cuts at the selected length.
Even if the real original length is shorter or longer than the selected length,
taking into account the zoom factor and the leading/trailing edge setting, the
cut will be made at the selected length.
▼ ▼ ▼ ▼
Selecting synchro or standard cut
1
Press the ‘cut’ button to select the cut mode you want. The indicator of the
chosen cut mode will light.
If you select standard cut:
2
Press the ‘up’ or ‘down’ button’ to select the required cut length.
The required length is shown in the operating display. You confirm the setting
by pressing the zoom, edge, cut, media or start button.
For an overview of the possible standard lengths refer to ‘Order of standard
sizes for using standard cut’ on page 140.