Oce 9400-II, User Manual

Page: 62 / 167

62 Océ 9400-II User Manual
Attention:
If you do not wait until the message ‘FEED SHEET’ appears, you
may get a paper jam, or a print job is using the wrong sheet of paper.
Note:
Manual feed time-out (see ‘Setting the time-out for manual feed’ on
page 50).
Reduction/enlargement
With the Océ 9400-II you can reduce or enlarge your original from 25% to
400%. By pressing the ‘zoom’ button you can toggle between the fixed step
zoom mode or the % zoom mode. In fixed steps mode 8 pre-set zoom settings
are available. You can select the zoom factor by means of the ‘up’ or ‘down’
button when the indication is flashing. Also refer to ‘Overview of standard
zoom formats’ on page 139.
▼ ▼ ▼ ▼
Making reduced/enlarged copies with pre-set zoom settings
1
Press the ‘zoom’ button to activate the steps zoom mode.
2
Press the ‘up’ or ‘down’ button to select the required reduction/enlargement
ratio.
The display shows the chosen ratio. If you make adjustments using this button,
one of the indications above the button is flashing. If the adjustment differs
from the default setting, the indication remains on. You confirm the setting by
pressing the zoom, edge, cut, media or start button.
▼
▼ ▼
▼
Making reduced/enlarged copies with 1% steps
1
Press the ‘zoom’ button to activate the % zoom mode.
2
Press the ‘up’ or ‘down’ button to select the required reduction/enlargement
ratio.
The display shows the chosen ratio. If you make adjustments using this button,
one of the indications above the button is flashing. If the adjustment differs
from the default setting, the indication remains on. You confirm the setting by
pressing the zoom, edge, cut, media or start button.