Oce 9400-II, User Manual

Page: 17 / 167

Getting started 17
■
During the copying process:
If you press this button while an original is being fed, the copying process
will stop immediately. If you want to abort a multicopy job after the scanning
of the original is finished, you must abort the copying process by pressing the
‘cancel/continue’ button on the printer. You have to open the top cover of the
scanner to remove the original (‘Clearing original jam’ on page 126).
Media button
With this button you choose the input of the copy material.
Possible input selections are roll 1, roll 2 or manual feed.
Exposure scale
You modify the exposure level with the ‘lighter’ and ‘darker’
buttons. The exposure level can be changed at all times.
Auto exposure button
With this button the Automatic Background
Compensation can be switched on or off.
Cut button
This button toggles between synchro cut mode and standard cut
mode.
In synchro cut mode, the copy is cut at the length of the original.
In standard cut mode, the copy is cut at a standard length.
Edge button
This button toggles between leading and trailing edge. With this
button you add or remove a strip at the leading or trailing edge.
Zoom button
You can vary the zoom factor between 25% and 400%. Either in
fixed steps or percentages.
Up/Down buttons
When using zoom-, edge- or the standard cut-mode you can
modify the values of these modes by pressing the up or down button.
Start indication
This indication above the start button is on if the scanner is
ready to make a scan and is off when the scanner is scanning an original. Also
this is the only indication which is on when the scanner is in standby mode.
Please wait
This indication is blinking when the user has pressed the start
button but the system is not ready to scan. E.g. because the system is busy with
a multicopy job or because the system is processing a printjob.
Printer error
This indication is on if there is an error on the printer. Check the
operating panel of the printer for the error message.