WHAT TO DO
IF YOUR IN A
HURRY
6
PLAYING THE MA TRIX-6R
If you absolutely
MUST
start now, take the next five minutes and read
the following:
1 . HOOK IT UP
-
Refer to the HOOK-UP diagram shown on Page 8.
Make sure you use the right cables.
The MATRIX-GR must be used as a SLAVE, so connect the M IDI
OUT of the Master instrument to the MIDI I N of the
MATRIX-GR.
2. TURN IT ON
-
The POWER SWITCH is on the front panel in the
lower right-hand corner. Flip it up.
3. TUNE IT UP
-
Press the orange MASTER button. Press the
second grey button right below the display. The display will
read "
TUNING
.
.
.
" which will take all of three seconds.
4.
SELECTING PATCHES-
Press the blue PATCH ES button
and the PATCH SELECT light should go on. If not, press the
blue PATCHES button a few times as the lights will "loop"
around the three headings.
When PATCH SELECT is lit up, you can select any one of the
MATRIX-GR's 1 00 patches numbered 00 through 99. Typing
in 2-digit numbers on the Keypad or using the
< >
or
<<
>>
buttons will change patches.
<
>
change values by
1 .
<<
>>
change values by
5.
6. SELECTING SPLITS
- Press the grey S PLITS button. The l ight
next to SPLIT SELECT should come on. If not, press SPLITS
again and it will. You can now use the Keypad,
< >
or
<< >>
bottons to select any one of the MATRIX-GR's 50 SPLIT
programs numbered 00 through 49.
7. ADJUST THE VOLUME
- The VOLUME slider controls the
volume of both the main outs on the back panel and the
Headphone jack in the front simultaneously. Pushing it up
gives an increase in volume. Pulling
it
down decreases the
volume.
Matrix-GR Owner's Manual