STEP
6:
Go back to PARAMETER Mode.
STEP
7:
Type in number
"33"
on the Keypad. W e will now select
LF01 as the TRACK's INPUT.
STEP
8:
Select the VALUE Parameter.
STEP
9 :
Type i n number
"04"
on the Keypad. LF01 has now
been selected as the TRACK's INPUT and is our
modulation source.
STEP
1 0 :
Press the blue PATCHES button again once to enterthe
MATRIX MOD Page. We will now set up the modulation
routing using the Tracking Generator.
STEP
1 1 :
Select the NUMBER Parameter.
STEP
1 2:
Press the #4 button on the Keypad to access the fifth
modulation route. The display will be blank to show that
this MATRIX MOD is available.
STEP
1 3:
Select theSOU RCE Parameter.
STEP
1 4:
Type in the number
"1 1 "
on the Keypad and the word
" TRAK
"appears on the display. We have now selected
the Tracking Generator as our modulation source.
STEP
1 5:
Select the AMOUNT Parameter.
STEP
1 6:
Use the >> button on the Keypad to advance the VALUE
to +63. We'll use a maximum modulation amount for the
most audible effect.
STEP
1 7:
Select the D ESTINATION Parameter.
STEP
1 8:
Press number
"01 "
on the Keypad and the display reads
"DC1 FR ".
This indicates that we have selected DC01 's
FREQU ENCY, or its basic pitch, as the modulation
destination.
STEP
1 9 :
Press the blue PATCHES button repeatedly until the
PATCH EDIT light is lit. We are now back in the PATCH
EDIT page.
STEP
20:
Enter PARAM ETER Mode.
STEP
21 :
Type in the number
"82"
and the display reads
"LF01
TRI
". This indicates that we are ready to select a
waveform that we will manipulate with TRACK.
STEP
22:
Select the VALUE Parameter.
Matrix-6R Owner's Manual
41