STEP
8:
When you are finished editing the Basic Patch, you must
STORE it into memory if you intend to keep it. But before you STORE
your new patch, remember that typing in the patch Number erases the
patch that is in that location and replaces it with the one you just
edited. Also, remember that the MATRIX-6R must be in PATCH
SELECT
I
Number Mode before STORE can take place.
PATCH I NITIALIZE sets all the Basic Patch VALUES to settings called
"defaults". A default is simply a choice that the MATRIX-6R's computer
makes for every Parameter VALUE when told to initialize a patch. Each
of these Values represent a setting that you can most easily use as a
starting point when creating a new patch. Defaults will remain as they
are until you change them and are Stored with the patch.
52 CALI BRATE
This Parameter takes up where the TUNE ("Auto Tune") function in
the MODE SELECT
I
MASTER EDIT Page leaves off. Where TUNE
simply fine tunes the DCOs, CALIBRATE performs precise
adjustments to the VCF Frequency, Pulse Widths, Resonance
amount and VCA2 Level on each voice as well as resetting PEDAL 1
on the back panel. The CALI B RA TE procedure takes about 20
seconds to complete.
STEP
1 :
Enter the MASTER EDIT Page.
STEP
2:
Enter the 52 CALIBRATE Parameter. Make sure that if you
have a footpedal connected to the PEDAL 1 jack on the back panel, it
is set to its maximum OFF position.
STEP
3:
Enter VALUE mode and the display will read out
"REA D Y? ".
STEP
4:
Press the YES button and the display will read
"CALIBRA TING
" for about 20 seconds during the calibration
process.
When this routine is finished, the display will return to the
"52
CAL/BRA TE "
message .
IMPORTANT NOTE:
You should be careful not to use or disturb
the Pedal connected to the PEDAL 1 jack on the MATRIX-6R's back
panel during CALIBRATE since it is also being recalibrated while in
this Mode.
53 DISPLAY BRIGHTNESS
The brightness level of the display can be adjusted to suit your
personal needs. VALUE range is from + 1 to +31 . A VALUE of
1
is the
dimmest setting where the display is barely visible and a setting of
31
is the brightest. The
0-9
buttons on the Keypad as well as the
< >
and
<< >>
buttons can be used to make this adjustment.
Matrix-6R Owner's Manual
85
