2. N AME
As with single patches, you can give each of your SPLITS a
name. The only difference is that you can use up to six
characters instead of eight. Refer to the instructions on how to
program a NAME in the PATCH SELECT
I
NAME section.
LOWER I UPPER Patch Assignments
The basic construction of a SPLIT program is in choosing two existing
patches from among the MATRIX-6R's 1 00 single patch programs, using
one as the LOWER and the other as the UPPER. This is accomplished as
follows:
3. LOWER
4. U PPER
Select a single patch that you want to be played on the left part
of the keyboard. Using the 0-9, < > or << >> buttons on the
Keypad, enter the patch's 2- digit number. This will appear on
the display as the left number of the two PATCH numbers and is
now assigned to the LOWER part of the keyboard.
Select a single patch that you want to be played on the right part
of the keyboard. Using the 0-9, < > or << >> buttons on the
Keypad, enter the patch's 2-digit number. This will appear on the
display as the right number of the two PATCH numbers and is
now assigned to the UPPER part of the Master controller's
keyboard.
Modes of the SPLIT EDIT Page
The SPLIT EDIT Mode is where you program all of the performance
functions of a SPLIT. This mode allows you customize each SPLIT program
in any way you like. Thus, you have the versatility you need in setting up a
SPLIT that best suits your performance requirements.
1.
PARAMETER
2. QUICK
This mode allows you to select any one of the eight functions of
the MATRIX-6R that deal with the set-up of a SPLIT, numbered
O
through
7.
These PARAMETERS are printed on the
MATRIX-6R's top panel for convenience under the heading
SPLIT EDIT. These functions are explained later in this manual in
the chapter on SPLIT EDIT PARAMETERS.
When the PARAMETER mode has been entered, pressing a 2-
digit numberor the < > Or <<
»
buttons on the Keypad will
change from one SPLIT PARAMETER to another and will be
shown on the display.
The QUICK mode operates the same as it does in PATCH EDIT.
When in QUICK mode, the PARAMETER and VALUE modes of
SPLIT EDIT are accessed to be used at the same time. The
Matrix-6R Owner's Manual
25
