nVent.com
|
63
Raychem-AR-H58692-ACS30UIT2Programming-EN-1805
ASSIGNING CIRCUIT VOLTAGE
The Setup|Voltage window allows you to set the circuit voltage used to calculate the energy
consumption of the circuit.
Fig. 3.22
Setup|Voltage window (Floor Heating)
INPUT THE CIRCUIT VOLTAGE
Voltage: 120, 208, 240 or 277 V (Standard ACS-PCM2-5 panels) Since the C910-485
measures line voltage, this field does not appear.
Default:
208 V
ASSIGNING POWER CYCLE TEST
The Setup|Maint. window allows you to enable the Power Cycle test start time and frequency. After
the start time and frequency are entered the time of the next test will be displayed on this screen.
Note: If the circuit is disabled, forced on, or forced off, the power cycle test will be disabled until the
circuit is enabled.
Fig. 3.23
Setup|Maint. window (Floor Heating)
Input the start time and frequency for the Power Cycle test:
Power Cycle Start Time: The time of day to start the Power Cycle test
Range:
00:00 to 23:59
Default:
Each circuit is assigned a unique default start time calculated from the device
address and relay number.
