Nussbaum BT 610, Operating Instructions Manual

Page: 51 / 96

1 689 979 924N 26.11.07 51
It is not allowed to perform any repair work or other
work on a vehicle parked in the roller set of the brake
test stand.
The operators and users must wear working clothes ,
without loose bands and straps. You also have to wear
safety shoes without shoe strings.
Loose bands and shoe strings can enter into the roller
sets and endanger the operator.
Make sure that there are no persons in the test stand
area!
Danger to life for any persons in the test roller area.
Observe the prescribed statutory regulations for
prevention of accidents!
In case of danger, press the
„EMERGENCY STOP switch“ (13) !
Both roller sets will be activated without the touch
rollers being pressed down, when the push-button
„Einrichten“ (Set-up) and the push-button „Automa-
tik“ (Automatic) are pressed. -Therefore, it is not
allowed that any vehicle stands in the roller sets
unattended!
Danger to life for any persons in the test roller area!
In case of danger, press the
„EMERGENCY STOP switch“ (13)!
If the vehicle does not stand at right angles to the
test stand, it will drift!
Danger to life for any persons in the test roller area!
Adjust vehicle position by „leveling out“!
In case of danger, press the
„EMERGENCY STOP switch“ (13)!
If the vehicle „climbs“ out of the roller set, there is
danger to life for any person in the test roller area!
In case of danger, press the
„EMERGENCY STOP switch“ (13)!
De-energize the test stand before performing mainte-
nance work , e.g. changing of lamps and fuses.
Only qualified electricians are allowed to perform
works on the electric system.
Danger of
electric shock !
2. Safety instructions
Please observe the listed safety instructions for your own safety
and for your customer’s safety.
The safety instructions point out potential dangers. At the same
time, they explain how you can avoid these dangers by correct
behaviour.
The safety instructions are present again in the operating manual.
They are identified by the symbols
i
Information - draws your attention to certain important
facts
! ! ! ! !
Caution - calls your attention to danger for test device/
test sample
Danger for persons - general indication
or specific indications
Electric shock, danger of injuries, danger of burns etc.
As a reminder, the position of the
EMERGENCY STOP switch
is identified in this operating
manual by this symbol
2.1 Safety notes for the users
i The mounting screws of the covers must be securely
tightened in order to avoid tire damage.
!
Drive the vehicle slowly into the roller set in order to avoid
unnecessary stresses.
! Drive the vehicle slowly into the roller set in order to avoid
unnecessary stresses.
!
Do not start engines with drive motors of the test rollers.
!
Do not perform brake tests on motorcycles without having
installed the covers and devices provided for this purpose.
i If the brake test stand is not used , the power supply for the
test stand must be switched off by the main switch. -Secure
the main switch from unintended use. The roller sets of the
unused brake test stand must be
covered or protected by
barriers .
i Do not park vehicles on the brake test stand.