Instruction Manual
OCM F
OCM F - Rev. 04 as of 18.02.2014
Page 71
9.5.8 I/O Menu “Control Unit”
This menu is visible only if the controller has been enabled in the PAR menu.
Having the controller enabled will bring up the screen below:
1
Currently measured flow rate
2
Set point of regulator
3
Difference between Q
act
and Q
set
4
Regulator status: Normal, Quick close, Idle, Error
5
Current regulating time calculated from „Qdff” in sec./4
6
Time in seconds how long activated relay remains energised
7
Remaining cycle time
8
Status of three digital inputs
9
Status of both relays
Fig. 9-63
Control unit selection
9.5.9 I/O Menu “Test control unit – manual mode”
DANGER
Caution – Danger of injury!
The manual controller operation directly will access any following facility areas
without any safety locking measures!
This might result in personal injuries!
Manual operation is for test purposes exclusively!
Safety precautions must be taken!
This menu is visible only if the controller has been enabled. The slide valve can
be manually opened and closed for testing purposes. The arrow keys >up< and
>down< serve as manual control elements.
1
currently measured flow rate
2
time in seconds how long activated relay remains energised manually
3
status of three digital inputs
4
status of both relays
Fig. 9-64
Control menu for test control unit
Summary of Contents for osm-f
Page 24: ...Instruction Manual OCM F Page 24 OCM F Rev 04 as of 18 02 2014 Fig 7 3 Clamp wiring OCM F...
Page 102: ......
Page 103: ......
