Nivus osm-f, Operation Instruction Manual

Page: 17 / 103

Instruction Manual
OCM F
OCM F - Rev. 04 as of 18.02.2014 Page 17
6 Storing, Delivery and Transport
6.1 Receipt
Please check your delivery if it is complete and in working order according to
the delivery note immediately after receipt. Any damage resulting from transport
or transit shall be reported to the carrier instantly. An immediate, written report
must be sent to NIVUS GmbH Eppingen as well.
Please report any shortcoming due to delivery to your representative or directly
to NIVUS Eppingen within two weeks in writing.
Mistakes cannot be rectified later!
6.2 Delivery
The standard delivery of the OCM F measurement transmitter contains:
− the instruction manual with the certificate of conformity. All required steps to
correctly install and to operate the measurement system are listed herein.
− a OCM F transmitter
− a screwdriver with a 2.5 mm (0.098 in) blade for connecting the sensor inside
the terminal clamp housing
Additional accessories such as sensors, pressure compensation element (in
case of using sensors, type “KDA” with integrated pressure measurement cell

combi sensor), overvoltage protection, separate level measurements etc. de-
pending on order. Please check by using the delivery note.
6.3 Storing
The following storing conditions must be strictly adhered to:
Transmitter: min. temperature: - 30 °C (-22 °F)
max. temperature: + 70 °C (158 °F)
max. humidity: 80 %, non-condensing
KDA-Sensor: min. temperature: - 30 °C (-22 °F)
max. temperature: + 70 °C (158 °F)
max. humidity: 100 %
The devices must be protected from corrosive or organic solvent vapours, radio-
active radiation as well as strong electromagnetic radiation.