Instruction Manual
OCM F
OCM F - Rev. 04 as of 18.02.2014
Page 41
After mounting and installing sensor and transmitter (see previous chapters) ac-
tivate the power supply.
On initial start-up the unit will prompt the language selection:
Fig. 9-2
Language selection
Select the desired language with the >up< or >down arrow keys< and confirm
with >ENTER<.
9.2
Operation Mode (RUN)
This menu is a display menu for saved day totals and error messages. Contain-
ing the following submenus, it is not required for parameter setting:
Fig. 9-3
Operation mode selection
Day values
Please select submenu >Info<. This menu contains the total flow values of the
past 7 days (see Fig. 9-4).
Presumed the transmitter was operated without any interruption in the past
seven days. Otherwise it shows the total for the uninterrupted days of opera-
tion.
Only the first 3 days will be indicated after selecting. Browse to other days by
using the arrow key >down<.
The oldest day total will be overwritten as soon as the 24h-total of the 8. day
has been created des (circular memory function).
The flow totals of 24 hours will be indicated. Totalization normally is carried out
at 00:00 h (midnight). If desired, this value can be modified under RUN – day
values - cycle (see Fig. 9-5).
Additionally, you can erase all day counters under >erase counter<. Due to
safety reasons it is required to enter the PIN >2718< and confirmation with
ENTER after erasing.
Summary of Contents for osm-f
Page 24: ...Instruction Manual OCM F Page 24 OCM F Rev 04 as of 18 02 2014 Fig 7 3 Clamp wiring OCM F...
Page 102: ......
Page 103: ......
