Nidek Medical HandyRef-K, Operator'S Manual

Page: 69 / 130

63
OPERATING PROCEDURE: Other Measurements
3.7.2 Cataract measurement mode
When measurement is not possible due to cataract or abnormal eyes during AR (refractive error)
measurement, the device enters cataract measurement mode automatically.
1
Perform normal measurement.
When the device is placed in cataract measurement
mode, is displayed on the screen and then
measurement starts.

“3.4 Operating Procedure and Measurement
Method” (page 48)

“3.5.1 AR/KM measurement mode” (page
54) , “3.5.3 KM measurement mode” (page 58)
2
Cataract measurement mode is canceled when or is pressed, or when
or is changed.
●
Sample printout for cataract measurement mode
When data obtained in cataract measurement mode is
printed, “*” is added next to the measured values to
indicate that measurement was performed in cataract
measurement mode.
The factory setting is “NO”.
• In cataract measurement mode, measurement conditions are changed so that measurement results
can be easily obtained.
• In cataract measurement mode, be aware that measurement variations may occur more commonly
in comparison with normal measurement mode.
㸫㸫㸫㸫㸫㸫㸫㸫㸫㸫㸮㸮㸮㸯㸫㸫㸫㸫㸫㸫㸫㸫㸫㸫
㹌㸿㹋㹃ࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉࠉ㹋㸭㹄
ࠉࠉ
㸰㸮㸯㸲㸬㸯㸯㸬㸳
ࠉࠉࠉࠉࠉࠉ㸲㸸㸲
㸮
ࠉ㹎㹋
㹔㹂㸻㸯㸰㸬㸮㸮㹫㹫
㸺㹐㸼ࠉࠉࠉ㹑ࠉࠉࠉࠉࠉࠉ㹁ࠉࠉࠉࠉࠉࠉ㸿
ࠉࠉࠉ㸫ࠉ
㸯 㸬㸰㸳ࠉࠉ㸫 㸯 㸬㸮㸮ࠉࠉ㸯㸵㸵
ࠉࠉࠉ㸫ࠉ 㸯 㸬㸰㸳ࠉࠉ㸫 㸯 㸬㸮㸮ࠉࠉ㸯㸵㸲
ࠉࠉࠉ㸫ࠉ 㸯 㸬㸰㸳ࠉࠉ㸫 㸯 㸬㸮㸮ࠉࠉ㸯㸵㸳
ࠉࠉ㸺㸫ࠉ 㸯 㸬㸰㸳ࠉࠉ㸫 㸯 㸬㸮㸮ࠉࠉ㸯㸵㸳㸼
• When the measurement was performed in both quick measurement mode and cataract measure-
ment mode at the same time, “Q” is printed next to the measured values.