- 33 -
NEW LEADER • NL5000G5 AGCO
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
Header
Insert Installation
Figure 9
Figure 10
Figure 11
Figure 9 - Once both front pads make contact, insert hardware in front mount brackets’
lower
holes. Shim between
main bin and insert
brackets if distance is larger than 1/8” (.32cm). Tighten hardware per torque recommendations
in this manual.
Figure 10 - Make sure front feedgate is level. Lower endgate sealers so flush with chain shields and tighten
hardware.
NOTICE!
Leakage of material may occur if the sealer belts are not set properly on the front of the
insert. Highway Equipment Company is not liable for lost material due to improperly
installed sealer belts.
Figure 11 - Make sure there is a complete seal covering the gap between the insert and the main bin’s side sheets.
T
ighten all hardware on rubber sealers at front of insert.
Make sure rear pads are still in place against main bin. Install hardware in
lower
holes of rear mount brackets.
Shim between main bin and insert brackets if distance is larger than 1/8” (.32cm). Tighten hardware per torque
recommendations in this manual.
Make sure insert’s side sheets are not resting on top of main bin’s side sheets.
Install hardware in all four mount brackets’ upper holes. Tighten hardware per torque recommendations.
Remove hoist.
Inspect unit for foreign debris in conveyor area.
