- 35 -
NEW LEADER • NL5000G5 AGCO
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
Header
Insert Installation
Parts Needed:
Description
Qty
Divider - Lower Weldment
1
Bolt - Carriage 3/8-16NC x 1 SS
4
Washer - Flat 3/8 SS
8
Nut - Lock 3/8-16NC SS
4
Cover - Weldment Rear
1
Pin - Hair
2
1.
Remove hardware from rear two chain shield holes on
each side of MultApplier and set aside.
2.
Figure 1 - Install MultApplier Hillside Divider Support
(A) and fasten to MultApplier by reinstalling chain
shield hardware. Slip MultApplier Hillside Divider (B) up
into place and loosely install supplied hardware.
B
A
B
A
Figure 1 -
MultApplier Hillside Divider
3.
Verify that Divider is square by measuring from each
side of the Divider to the MultApplier chain shields.
Measurements must be equal.
4. Tighten all hardware to recommended torque.
5.
Figure 2 - Install Conveyor Cover (C) and secure with hair
pins D) on each side.
C
D
C
D
Figure 2
HILLSIDE DIVIDER & CONVEYOR COVER - MULTAPPLIER
The following steps apply to MultApplier units only. Continue to “Lower Divider - MultiBin” for MultiBin units.
NOTICE!
Highway Equipment Company will not be liable for misapplied material due to an improperly
adjusted divider, spreader or both.