- 45 -
NEW LEADER • NL5000G5 AGCO
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
Header
Bin 1: Main holding bin for material or Insert. MultApplier and MultiBin inserts (shown on following pages) are
configured as Bins 2-4 depending on type used.
Conveyor: Conveys material to rear of unit.
Conveyor Chain Oiler: Use to lubricate conveyor chain strands at the end of each day’s use to prevent premature
component failure.
Cylinder Control Valve Assembly: Contains control valves for all feedgate control cylinders, and spinner shift
cylinders.
Enclosure: Houses spreader control modules and fuse panel.
Feedgate: Adjustable gate mounted into Rear Endgate. Allows for variable rates of material flow by moving
hydraulic actuator to desired height.
Hillside Divider: Ensures balanced flow of material across conveyor when on hillsides or uneven terrain.
Inverted “V”: Mounted inside Main Hopper when Insert not installed. Distributes weight pressure across
conveyor, allowing for consistent material flow to Feedgate, and promotes an improved blend when spreading
fertilizer.
Lift Hooks: Used to lift unit or insert with appropriately rated lifting device.
Material Divider: Ensures uniform spread pattern by directing material off of conveyor onto spinner discs.
Material Divider Back Plate Storage: Storage position for material divider back plate when removed for spreading
lime.
Rear Endgate: Bolt-in endgate furthest from chassis cab (Rear based on direction of travel). Holds mounted
Feedgate, allowing for rear release of material from bin.
Side Stake: Side support for machine walls.
Sight Window: Allows viewing into Bin 1 from remote location, such as from ground or from vehicle cab.
Sill: Base of Main Hopper side walls. Contains Conveyor and supports machine walls.
Spinner Assembly: Contains adjustable G
5
Spreader system, consisting of hydraulic spinners used for dispersal
of various materials at different positioned settings allowing for consistent, even spread patterns across a wide
variety of material with a high rate of accuracy.
Spinner Deflectors: Deflect material away from machine.
Spinner Guards: Upper and Lower guards, protects operators from spinner discs. Must be in place during any
operation.
Spreader Control Valve Assembly: Contains control valves for Bin 1 conveyor, spinners and automatic conveyor
tension.
Vane Assembly: Precisely directs material from conveyor to spinner(s) as spinner assembly shifts left or right.
Introduction