- 36 -
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
NEW LEADER • NL5000G5 AGCO
Header
Insert Installation
LOWER DIVIDER - MULTIBIN
The following steps apply to MultiBin units only. Continue to “Hydraulics” for MultApplier units.
NOTICE!
Highway Equipment Company will not be liable for misapplied material due to an improperly
adjusted divider, spreader or both.
Parts Needed:
Description
Qty
Divider - Lower Weldment
1
Capscrew - 5/16-18NC x 1 SS
4
Washer - Flat 5/16 SS
8
Nut - Lock 5/16-18NC SS
4
AA
Figure 1
Figure 2
Figure 3
1.
Figure 1 - Make sure center fin is square to rear panel. Adjust as necessary.
2.
Figure 2 - Measure distance between Lower Divider fins to make sure they are all spaced equally. Adjust
bottom of fins as necessary.
3.
Figure 3 - Remove Vane Assembly (A) by pulling lynch pins and lowering latches on each side. Remove from
spreader and set aside.
