- 31 -
NEW LEADER • NL5000G5 AGCO
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
Header
Insert Installation
INSERT BIN INSTALL
WARNING
Use only lifting devices that meet or exceed OSHA standard 1910.184. Never exceed
work load limits or lift equipment over people. Empty spreader before lifting. Loads
may shift or fall if improperly supported, causing injury.
Before installing the insert:
Parts Needed:
Description
Qty
Insert Unit
1
Capscrew - 1/2 x 1 1/4 Grade 8
8
Flat Washer - 1/2 Grade 8
16
Lock Washer - 1/2 Grade 8
8
Hex Nut - 1/2 Grade 8
8
Make sure rubber sealer hardware is loose. If not, loosen.
Figure 4A
Figure 4B
To install insert bin:
Figure 4A - Hoist and slide insert into position between main bin’s side sheets.
Figure 4B - Align front and rear mount brackets.
Make sure insert is resting on inside of main bin, and not resting on tops of side sheets.
Release tension on hoist but do not remove.