- 28 -
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
NEW LEADER • NL5000G5 AGCO
Header
Installation
ELECTRICAL CONNECTIONS
Connect all electrical control circuits. All wiring should be approved automotive insulated wire, supported
adequately with insulating ties or straps, and located where it will not interfere with any control or access. Make
sure wiring does not contact any moving parts or sharp edge and is kept away from any hydraulic lines or any
heated part.
ISOBUS CONNECTIONS
A: Factory Supplied CAN-ISO Connector - Connects to
chassis harness.
•
Pin 1 - Battery Ground
•
Pin 2 - ECU Return (ECU Ground)
•
Pin 3 - 60-amp fused power
•
Pin 4 - ECU Power (Switched 12v)
•
Pin 5 - N/C
•
Pin 6 - TBC Power
•
Pin 7 - TBC Return
•
Pin 8 - ISO-BUS Can High
•
Pin 9 - ISO-BUS Can Low
60-amp power on pin 3 needs to be fused at battery
B: Factory Supplied Power Connector - Connects to
chassis harness.
B
A
B
A
Figure 8
•
Pin 1 - Hydraulic cooler fan power (Switched 12V)
• Pin 2 - Hydraulic cooler fan ground
•
Pin 3 - Body and lighting module ground
•
Pin 4 - Body and lighting module power (Battery 12V)
30-amp power on pins 1 & 3 must be fused at battery.