- 37 -
NEW LEADER • NL5000G5 AGCO
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
Header
Insert Installation
AB
Figure 4A
Figure 4B
Figure 5
4.
Figure 4A - Slide Lower Divider (B) between bottom of MultiBin and Spinner Divider as shown.
5.
Figure 4B - Lift Lower Divider to bottom of MultiBin, align holes and loosely install front and rear hardware.
6.
Figure 5 - Verify Lower Divider is square by measuring from each side to main bin’s chain shields. Make sure
distances are equal.
7.
Figure 6 - Reinstall Vane Assembly (A) and lock in place. Make sure
Lower Divider is centered over Material Divider. Contact Highway
Equipment Company if they cannot be aligned.
8.
Tighten front and rear hardware per torque recommendations. Refer
to “Standard Torques” in the “Lubrication and Maintenance” section
of this manual.
AA
Figure 6
