74
Options and programming methods
•
Partition filter
- if this option is enabled, the code will be able to change the
parameters only of codes with a lower rank in the system hierarchy whose partitions
are amongst the partitions assigned to the code being programmed.
For example, if a code is configured as “Master” with “Partition filter” and is assigned
to partitions 1, 3, 5 and 7, it will be able to enable/disable or change the PIN of a
“User” code assigned to partitions 1 and 5 but not the PIN of a “User” code assigned
to partitions 1, 2, and 3.
•
Text menu
and
User menu -
the combination of these two options allows
immediate visualization of the menu screens on the keypad displays after
acceptance of a valid user PIN. Refer to the following table.
Note
In all methods of access (A, B or C), the
key allows you to access/view the other cases via a
circular buffer, see figure.
•
AnnounceShortcut
- if enabled on a voice capable keypad, the descriptions of all
the shortcuts assigned to the code and associated with the number keys will be
announced after acceptance of the entered PIN.
Note
Set the “Loc.KpadMess Time” (refer to
paragraph 6-27 Other parameters
) to allow the system to
play the messages associated with all the shortcuts assigned to number keys
, ...,
.
•
Remote access -
if enabled, the code PIN can be used to operate the system from
any remote telephone.
If the code PIN is entered on a remote telephone keypad, only the shortcuts associated
with keys 0 to 9 can be used to:
•• Arm/Disarm
•• Stop alarms
•• Clear call queue
•• Delete memory
•• Activate outputs
•• Deactiv. outputs
•• Listen-in
•• Arming status
Any other type of command will have no effect.
•
Patrol
- if enabled, the code will be able to disable the system for the pre-set “Patrol
time”.
•
Fixed length
- if enabled, after typing in a PIN and without pressing the
key,
the user will be able to activate the shortcut associated with function key “F12”,
programmed via the “F1/4KeyShortcuts”, described later.
If this shortcut is number 1 (“Arm/disarm”) and all the partitions assigned to the
user code in question are disarmed, the command will arm them, otherwise it will
disarm them.
A user code with this option enabled has access to its own menu only after pressing
the
key and PIN entry.
F1/4KeyShortcuts
This section allows you to programme up to 12 shortcuts associated with keys
, ...,
. After valid PIN entry, the keypad will show the icons that correspond to keys
, ...,
and which are associated with these shortcuts. Press the corresponding
key to activate the respective shortcut.
Case
Text menu
User menu
Description
A
Disabled
Enabled
Accesses the user-menu (shown as a list of operations
the user is enabled to perform); at this point the user
can scroll the list using
and
and select the
required option.
B
Disabled
Disabled
Visualization of the user-icons associated with function
keys
, ...,
; at this point the user can press
the required function key and activate the associated
shortcut.
C
Enabled
Disabled
Shows the descriptions of the personalized user-icons
associated with function keys. instead of the shortcut
icons. The user can use
and
to scroll the
list of shortcut descriptions and select the desired
shortcut, which can be activated by means of the
key.
D
Enabled
Enabled
The same as “
C
”
User Code
User Code
Manage alarms
Arm/Disarm op.
Voice functions
User Code
Stop alarms
Delete memory
Nexus status
(A)
(B)
(C)