36
Installation
3-3-4
Addressing FLEX5 expansions and the
Air2-BS100 transceiver
Using a small screwdriver or similar tool, set the expansion board address on the 8-
segment DIP-Switch strip (
Table 21: Flex5 - description of parts, C
). Each segment can
be set at “1” (On) or “0” (Off).
The figure shows some examples.
3-3-5
Addressing nBy readers
To assign addresses to the system readers, follow the instructions described in
paragraph 3-3-5 Addressing nBy readers
or work carefully through the following steps:
1. Put the control panel in “Maintenance” mode (
paragraph 3-1-10 Maintenance sta-
tus
).
2. Start the “Address Programming” phase using the software or from a keypad:
Type-in Code
(Installer PIN)
, PROGRAMMING Readers
, Prog. address
.
or
via the software select “Proximity readers”, go to the “Programming” section and
then click on “Proximity Reader address configuration”.
3. Each reader indicates its own address on its LEDs (refer to the Table in
paragraph
3-3 Addressing the peripherals
).
4. Hold a valid key in the vicinity of the reader. The reader will run through a series
of available reader-addresses (an address every 2 seconds). Remove the key
when the LEDs indicate the desired address.
5. The reader will hold the addressing phase for a further 10 seconds, in order to allow
you to change the address if necessary.
6. The reader will assign the selected address when the 10 second period expires.
7. If you wish to assign an address to another reader, hold a valid key in the vicinity
of the reader and work through points 4 to 6.
8. End the reader-address programming phase (exit “Prog. Address” menu via key-
pad or, if you are using the SmartLeague software, by clicking on “Stop reader
address setup”.
3-4
Auto-enrolling peripherals
The peripherals connected to the BUS are enrolled automatically in the following
situations:
•
on first startup (refer to
Chapter 4 - First power up
)
•
in “Maintenance” mode (refer to
paragraph 3-1-10 Maintenance status
)
•
from the Installer menu (refer to
paragraph 6-25 Default settings
)
Type in Code
(Installer)
, PROGRAMMING Default settings
, Auto enroll Periph
.
ON
1 2 3 4
5 6 7 8
Position 1
Position 2
ON
1 2 3 4
5 6 7 8
ON
1 2 3 4
5 6 7 8
ON
1 2 3 4
5 6 7 8
Expansion n. 1
Expansion n.29
Expansion n.40
This procedure does
not apply to readers
that are built into
the keypads.
