Ness SmartLiving 10100, Installation & Programming Manual

Page: 38 / 112

38 Installation
3-5-3
Double (Dual EOL) balancing
Double balancing (also known as 4 State Monitoring) discriminates 4
distinct conditions on the zone terminal:
•
standby
• alarm
• tamper (short-circuit)
• tamper (wire cutting)
For each of these, the control panel reads different resistance values on
the terminal, expressed below in Ohm.
3-5-4
Double-Zone balancing
Double zones without EOL resistor can discriminate 5 conditions on the
entire terminal:
•
standby on both zones
• alarm on zone 1 and standby on zone 2
• alarm on zone 2 and standby on zone 1
• alarm on both zones
• tamper (wire cutting)
For each of these, the control panel reads different resistance values on
the terminal, expressed below in Ohm.
3-5-5
Double Zone balancing with EOL
Double zones with EOL resistors can discriminate 6 conditions on the
entire terminal:
•
standby on both zones
• alarm on zone 1 and standby on zone 2
• alarm on zone 2 and standby on zone 1
• alarm on both zones
• tamper (wire cutting)
• tamper (short-circuit)
For each of these, the control panel reads different resistance values on
the terminal, expressed below in Ohm.
Ohm Zone
> 6800 tamper (wire cutting)
6800 alarm
6800 / 2 standby
0 tamper (short-circuit)
A
l
a
r
m
+12V GND
Ta
mp
er
6K8Ohm
1/4W
Ohm
Zone 1 Zone 2
(double)
> 3900 + 6800 tamper
3900 + 6800 alarm alarm
6800 standby alarm
3900 alarm standby
0 standby standby
A
l
a
r
m
+12V GND
Ta
mp
er
A
l
a
r
m
+12V GND
Ta
mp
er
3K9Ohm
1/4W
6K8Ohm
1/4W
Zone 1
Zone 2
Ohm
Zone 1 Zone 2
(double)
> 2 x 3900 + 6800 tamper (wire cutting)
> 2 x 3900 + 6800 alarm alarm
3900 + 6800 standby alarm
2 x 3900 alarm standby
3900 standby standby
0 tamper (short-circuit)
A
l
a
r
m
+12V GND
Ta
mp
er
A
l
a
r
m
+12V GND
Ta
mp
er
3K9Ohm
1/4W
6K8Ohm
1/4W
Zone 1
Zone 2