B-2 System Board Jumpers
CHANGING PROCESSOR JUMPER SETTINGS
Use the following procedure when replacing the installed processor with a faster speed
processor. Jumpers requiring setting changes include the Processor/Bus Speed and ATCLK
jumpers.
1.
Turn off and unplug the system and any connected external options.
WARNING:
System power must be off before
removing the cover and changing a jumper
setting.
2.
Remove the system unit cover (see Section 3, Option Installation, for cover
removal).
3.
Replace the processor (see Section 3 for processor upgrade procedures).
4.
Remove any expansion boards blocking access to the jumpers.
5.
Locate the Processor/Bus Speed, ATCLK, and Processor Voltage jumper blocks
on the system board (see Figure B-1).
6.
Set the Processor/Bus Speed and ATCLK jumpers per Figure B-2 and
Figure B-3.
CAUTION:
Unless updating the processor,
leave the processor jumpers at the factory
setting. Changing the settings jumpers could
damage the processor.
7.
Set the Processor Voltage jumper (see Figure B-2 and Figure B-3) on the system
board as follows:
NOTE:
System boards have either one or two
BF processor jumpers. The system board with
two BF jumpers are labeled BF0 and BF1 (see
the following figures).
Summary of Contents for POWERMATE
Page 14: ...xvi Preface ...