Option Installation 3-19
Processor Installation
1.
Remove the processor currently in the system (described in the previous
procedure).
CAUTION:
Before picking up the processor,
reduce static discharge by touching the metal
frame of the system unit.
2.
Align the notched corner of the processor with the alignment corner in the socket
and insert the processor.
3.
Swing the lever down to lock the processor into the socket.
CAUTION:
Remember to either reattach the
heatsink used with the old processor or install the
new heatsink supplied with the upgrade
processor.
4.
Check to see if the newly installed processor requires a system board jumper
change (see Appendix B, “System Board Jumpers”).
5.
Replace any boards removed during this procedure.
6.
Replace the system unit cover.
MIDI/JOYSTICK UPGRADE
The system comes with a MIDI/joystick connector on the system board. Installing the
optional MIDI/joystick kit provides an MIDI/joystick connector at the rear of the system.
Install the optional MIDI/joystick kit as follows.
1.
Remove the system unit cover as previously described.
2.
Locate the MIDI/joystick connector on the system board (see Figure 3-13).
If any expansion boards are obstructing the connector, remove the boards.
3.
Locate the small connector end of the MIDI/joystick cable.
4.
Align pin 1 on the small connector with pin 1 of the MIDI/joystick connector on
the system board.
Summary of Contents for POWERMATE
Page 14: ...xvi Preface ...
