![background image](http://html.mh-extra.com/html/nec/powermate/powermate_service-manual_248634112.webp)
3-40 Option Installation
6.
Connect the device cables.
7.
Replace the system unit front panel (see Replacing the Minitower Front Panel).
8.
Replace the minitower system unit cover.
NOTE:
If a 1.2-MB diskette drive was
installed, remove the protective cardboard insert
from the drive.
9.
Run the Setup program to set the new configuration.
Replacing the Minitower Front Panel
Replace the minitower front panel only after it has been removed in a 5 1/4-inch device
installation.
1.
Route the LED and IR cables on the front panel through the chassis to the system
board, and connect the cables to the board.
2.
Align the six front panel metal clips with the holes in the front of the system unit
(see Figure 3-43).
3.
Evenly press the front panel into position until the clips lock the panel in place.
One of Six
Metal Clips
Front Panel
Figure 3-43 Aligning the Minitower Front Panel
4.
Go to Step 8, Installing the Minitower 5 1/4-Inch Device, to complete the
installation.
Summary of Contents for POWERMATE
Page 14: ...xvi Preface ...