3-28 Option Installation
Removing the Desktop 3 1/2-Inch Drive Bracket
The 3 1/2-inch drive bracket containing the diskette drive must be removed before installing
any 3 1/2-inch and 5 1/4-inch devices. Remove the bracket as follows.
1.
Remove the desktop system cover as previously described.
2.
Remove the screw securing the drive bracket to the chassis (see Figure 3-27).
3.
Slide the bracket to the rear of the chassis to release it from the three bracket tabs.
4.
Carefully lift the drive bracket up and place it on top of the power supply.
Figure 3-27 Removing the 3 1/2-Inch Drive Bracket
Installing the Desktop 3 1/2-Inch Drive
Install a hard disk drive into the desktop drive bracket as follows.
1.
Remove the system unit cover as previously described.
2.
Remove the 3 1/2-inch drive bracket from the system unit (see Removing the
Desktop 3 1/2-Inch Drive Bracket).
3.
Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
4.
Insert the hard disk drive so that the connectors extend out of the bracket on the
same end as the standard diskette drive connectors.
5.
Align the holes in the hard disk drive with the holes in the bracket.
3 1/2-Inch
Drive Bracket
Tabs
Tab
Screw
Power
Supply
Summary of Contents for POWERMATE
Page 14: ...xvi Preface ...