NEC N8100-1575F, User Manual, Page: 90 / 378

4-14 Configuring Your Server
Peripheral Configuration
IMPORTANT:
Note that the interrupt and/or base I/O address are not
overlapped with others. If the value set for the interrupt or base I/O
address is used in another resource, the yellow asterisk (*) appears.
Reset any item with the yellow asterisk properly.
Option Parameter Description Your Setting
Serial Port A Disabled
[Enabled] Selects whether serial port A is enabled or
disabled.
Base I/O
address [3F8h]
2F8h
3E8h
2E8h Selects the base I/O address for serial port
A.
Interrupt IRQ 3
[IRQ 4] Selects the interrupt for a serial port A.
Serial Port B Disabled
[Enabled] Selects whether serial port B is enabled or
disabled.
Base I/O
address 3F8h
[2F8h]
3E8h
2E8h Selects the base I/O address for serial port
B.
Interrupt [IRQ 3]
IRQ 4 Selects the interrupt for a serial port B.
USB 2.0 Controller Disabled
[Enabled] Selects the USB 2.0 controller is enabled or
disabled.
Serial ATA Disabled
[Enabled] Selects whether the serial ATA is enabled or
disabled.
SATA AHCI [Disabled]
Enabled Displays whether AHCI (Advanced Host
Controller Interface) is enabled or disabled.
(View only)
This option is enabled when SATA RAID is
enabled.
SATA RAID [Disabled]
Enabled Displays the RAID configuration jumper
switch is set to [RAID enable] position or
not. (View only) See Chapter 4 for details.
[ ]: Factory-set
IMPORTANT: To use the remote media feature of EXPRESSSCOPE
Engine 2, select "Enabled" for [USB 2.0 Controller].