Upgrading Your Server 11-45
Installation
See "PCI Board" in this chapter and manual that comes with the optional RAID Controller for the
installation of a RAID Controller (N8103-116A/117A/118A).
IMPORTANT:
When the RAID Controller is connected, the boot
priority specified in BIOS SETUP utility must be eighth or younger. If
specified ninth or later, the configuration menu of RAID Controller will
fail to start.
Setting of Jumper Switches on Mother Board and Backplane Board
To use the optional RAID Controller (N8103-116A/117A/118A), you need to change jumper switch
setting on the mother board and the backplane board.
See "Use of Internal Hard Disk Drives In the Raid System" for jumper pin locations.
Jumper pin on mother board (SATA_RAID)
SW-RAID configuration jumper switch
Disable (2-3)
1 2 3
Backplane board
Controller configuration jumper switch
3.5-inch hard disk drive model
2.5-inch hard disk drive model
Optional RAID
3
2
1
Controller (2-3)
1
2
3
Removal
Remove the optional RAID Controller in reverse order of the installation steps.
If you use the server with the optional RAID Controller being removed, be sure to install the
additional slot cover that has been removed from the riser card. Secure the additional slot cover with
the screw.
Summary of Contents for N8100-1575F
