1. Installing Internal Optional Devices
Express5800/R120h-1M User’s Guide
90
Chapter 2 Preparations
Installing tertiary riser card (full-height) N8116-54
You can fit a full-height/ three-quarter length PCI board on this riser card.
Please prepare the following before installing the option.
To use this option, CPU 2 is required.
Parts included in the option kit
PCI board to be installed
Important The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
To install the components, follow these steps.
1.
See steps 1 to 6 in
Chapter 2 (1.2 Overview of Installation and Removal)
for preparations.
2.
Pick up the both end part of the primary riser card and lift them up to remove.
