NEC Electra Elite 48/192, Features And Specifications Manual

Page: 102 / 652

Electra Elite Issue 6
Features and Specifications Manual A - 81
4. Press
T
(outgoing telephone number is displayed in the
LCD). When the outgoing telephone number is longer than nine
digits, continue to press
T
to display each remaining digit.
SERVICE
CONDITIONS Data Assignment:
Use Memory Block 1-4-00 (Tandem Transfer Automatic Disconnect
Time Selection) to establish a disconnect time (default: 1 hour) to
release an Automatic Trunk-to-Trunk Transfer.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
Selection 1] Page 1 LK7 to Allow (default: LED On) or Deny (LED
Off) set/cancel of the Automatic Trunk-to-Trunk Transfer feature by
Attendants.
Use Memory Block 3-04 (Trunk-to-Trunk Transfer Yes/No Selection)
to allow (YES) or deny (default: NO) Automatic Trunk-to-Trunk
Transfer. The CO/PBX providing the outside line must provide a
timed-disconnect signal.
Use Memory Block 3-06 (Automatic Tandem Trunk Assignment) to
assign the incoming and outgoing trunks to be used for Automatic
Trunk-to-Trunk Transfer.
Restrictions:
Outgoing trunks cannot be used when this feature is set.
Automatic Trunk-to-Trunk Transfer and Automated Attendant cannot
be set for the same trunk at the same time.
General:
When this feature is activated, and an incoming call rings in, any
ringing assigned station rings and the call can be answered while the
outgoing call is being made.
The incoming or outgoing trunk can be a CO/PBX or Tie/DID line.
The Attendant can press the Feature key and the line key to verify
the Automatic Trunk-to-Trunk Transfer status when set.
When the outgoing line is in use and an incoming call rings in, the
call is treated as a normal incoming call. When the outgoing line
becomes free, the Automatic Trunk-to-Trunk Transfer feature is
activated.
When this feature is activated, the incoming trunk LEDs assigned on
Multiline Terminals wink and the outgoing trunk LEDs are always On.