119
Test Mode
Inspection and Service
Troubleshooting
8B. Service
- Must be performed by a technician -
(3) Inside the Corner Rail (L) or (R)
The description below explains how to remove jammed pucks from the (L) side. Follow the same procedure
to remove jammed pucks from the (R) side.
z
To avoid electric shock, accidents or injuries to yourself or other people, or damage to the electronic
circuits, be sure to turn off the power switch before starting work.
Turn off the power switch. (See “7-6-1 Turning the Power Switch On” on page 39.)
Open the service door L. (See “8A-5-2 Opening and Closing the Service Doors L and R” on page
107.)
Insert a rod (wrench, etc.) into the gap of the corner outer R (L), and remove the jammed puck.
Corner outer R (L)
Rail (L) assembly
Wing bolt (M4 x 10)
Corner rail cover (L)
[If the jammed puck cannot be removed by the above procedure, perform the procedure below.]
Remove the rail (L) assembly by reversing the installation procedure. (See steps
-
of
“8A-2-5 Installing the Side Tower Assembly” on page 96.)
Remove the two wing bolts (M4 x 10), and remove the corner rail cover (L).
Open the corner outer R (L) slightly, insert a rod (wrench, etc.) into the gap, and remove the
jammed puck.
To install, perform the procedure in reverse.
M259_08B_ENin6.indd 119
M259_08B_ENin6.indd 119
2/5/2013 8:11:49 AM
2/5/2013 8:11:49 AM
