Tractor-ECU application
Parameter
8
30322538-02-EN
V9.20191001
55
“Sensor Type” parameter
If a work position sensor is connected to the terminal via connector B, you must tell the terminal the
principle according to which the sensor functions.
Possible values:
▪
“analog”
You are using an analog work position sensor [
56], which measures the height of the hitch
linkage as a percentage.
▪
“digital”
You are using a digital, ISO-compatible work position sensor in accordance with ISO 11786. The
sensor is connected to the terminal via the signal socket.
▪
“ME-sensor Y”
You are using a work position sensor provided by Müller-Electronik. The sensor is connected to
the terminal.
“Inversion” parameter
As a standard, the terminal assumes that the implement is in work position as soon as the work
position sensor sends a signal. However, if the work position sensor functions inversely, you have to
set it here.
Possible values:
▪
“Yes” - implement is in work position when the sensor is not occupied.
▪
“No” - implement is in work position when the sensor is detecting something.
PTO shaft speed
Configuring the PTO (power take-off) rotational speed sensor. It measures the rotational speed of the
PTO.
Possible values:
▪
“deactivated”
No sensor measures the rotational speed of the PTO.
▪
“Revol. sensor - front”
A rotational speed sensor that is fitted onto the front PTO.
▪
“Revol. sensor - rear”
A rotational speed sensor that is fitted onto the rear PTO.
Impulses per revolution
Number of impulses per revolution that are transmitted by the PTO through the selected PTO sensor.
Calibrating the speed sensor
When calibrating the speed sensor using the 328.085ft (100m) method, determine the number of
targets which the speed sensor encounters over a distance of 328.085ft (100m).
If you know the number of targets for the speed sensor, you can also input this manually.
You have measured and marked a distance of 100m. The distance must correspond to the field
conditions. You must therefore drive across a meadow or a field.
The vehicle with the connected implement is operational for a 100m drive and is at the start of
the marked distance.
You have connected a wheel sensor or radar sensor to the terminal.
8.3.1
Procedure
