Muller TOUCH800, Installation And Operating Instructions Manual

Page: 35 / 85

Connecting and configuring external devices
GPS receiver
6
30322538-02-EN V9.20191001 35
5. - Confirm.
6. For TRACK-Leader AUTO® systems, tap and adjust the baud rate of the receiver to the
automatic steering.
⇨
The following message appears: “You can now disconnect the GPS receiver.”
7. Confirm using “OK”.
8. Switch off the terminal.
9. Now connect the GPS receiver to the cable harness of the steering job computer.
10. Start the terminal.
11. Depending on the steering job computer, activate the “PSR CAN” or “TRACK-Leader AUTO”
driver. [
➙
28]
12. - Confirm.
13. Restart the terminal.
⇨
The GPS receiver is now configured for automatic steering.
To change parameters for the GPS receiver after the GPS receiver has been configured for
automatic steering, you must restore the internal settings of the GPS receiver.
1. Connect the GPS receiver to the terminal.
2. Activate the driver for the respective GPS receiver. [
➙
28]
3. Restart the terminal.
4. - Open the “Service” application.
5. Tap “GPS”.
6. - Reset the baud rate.
7. The following message appears: “Should the standard baud rate be restored?”
8. Confirm using “OK”.
9. Restart the terminal.
⇨
You can now change the individual parameters for the GPS receiver.
⇨
After you have changed the parameters, you can reconfigure the GPS receiver for the steering.
Recording GPS position
Certain faults can require recording of the position data from the GPS receiver.

A USB memory device is inserted into the terminal.
1. - Open the “Service” application.
2. Tap “GPS”.
3. Tap “GPS data”.
⇨
The “GPS data” screen appears.
Procedure
6.1.4
Procedure