5
Basic control principles
Initial start-up
20
V9.20191001
30322538-02-EN
Setting
Where?
Purpose
Enter the tractor geometry and
activate the tractor profile.
/ Settings
See:
- Managing the tractor profiles [
Virtual job computer
/ Settings
For the system to be able to
know the working width and
other parameters of the
machine, you must create a
virtual job computer for every
non-ISOBUS-compatible
machine that you use.
See: Virtual ECU application [
Other settings must be made in the TRACK-Leader application.
Operating ISOBUS implement
To operate an ISOBUS job computer with the terminal, it is sufficient to connect the job computer to
the rear ISOBUS socket. As a standard, the terminal disposes of the required licences.
The “ISOBUS-UT” licence is activated.
1.
Insert the ISOBUS cable of the job computer into the ISOBUS rear socket.
2.
Switch on the terminal.
3.
Wait until the job computer application has copied all of the relevant data on the terminal.
4.
Open the job computer application using the selection menu [
Terminal for automatic section control
Most important settings
Setting
Where?
Commentary
Select the GPS driver
(optional).
/ Driver / GPS [
The standard driver works in
most cases for the receivers
sold by ME. However, to
change the correction signal, a
fitting driver for the GPS
receiver must be activated.
Enter the tractor geometry and
activate the tractor profile.
/ Settings
See:
- Managing the tractor profiles [
5.2.2
Procedure
5.2.3
