4
Mounting and installation
Inserting micro-SD card
18
V9.20191001
30322538-02-EN
When there is more than one terminal in the tractor cab, you may need to change certain settings in
order to enable two-way communication. Find out more: Using two terminals [
1.
Connect the 9-pin connector A of the basic vehicle harness to the CAN port of the terminal.
2.
Tighten the safety screws on the connector.
Inserting micro-SD card
The micro-SD card serves as internal storage for the terminal.
To change the SD card:
1.
Switch off the terminal and disconnect all cable connections.
2.
Unscrew the cover on the rear of the terminal.
3.
Use your finger to press on the SD card in the slot.
⇨
The SD card is unlocked and now protrudes by approx. 1 mm.
4.
You can remove the card.
5.
To lock the card again, press the card lightly into the slot until it is locked again.
6.
Screw the cover back onto the rear of the terminal.
Using two terminals
The following table will tell you which settings you need to configure to be able to use two terminals,
and the sections in which these are described. The specifications on the in-cab terminals are without
liability.
Settings for the ME terminal and in-cab terminal
Possible purpose
Setting of the ME terminal
Setting of the in-cab terminal
TRACK-Leader and SECTION-Control on
the ME terminal.
Operation of the job computer on the in-
cab terminal.
Login as ISOBUS terminal: No [
Activate the ISOBUS terminal (JohnDeere:
Implement Bus; Fendt: Fendt ISOBUS
terminal).
Deactivate Task Controller (JohnDeere:
Task Controller; Fendt: Taskcontroller).
TRACK-Leader, SECTION-Control, and
job computer operation on the ME
terminal.
Login as ISOBUS terminal: Yes [
Deactivate the ISOBUS terminal
(JohnDeere: Implement Bus; Fendt: Fendt
ISOBUS terminal).
Deactivate Task Controller (JohnDeere:
Task Controller; Fendt: Taskcontroller).
For JohnDeere, also deactivate:
Greenstar, Original Greenstar
Procedure
4.3
Procedure
4.4
