3
Product description
Applications on the terminal
12
V9.20191001
30322538-02-EN
USB port for:
Port A
CAN bus port for:
- ISOBUS basic vehicle harness [
- Connection to the tractor CAN bus
Port C
Serial port for:
- GPS TILT-Module
Port B
See section: Pin assignment connector B [
ETH port
M12 port for:
- Ethernet
CAM port
Port for an analog camera
Slot with the SD card
Applications on the terminal
The terminal is delivered with a range of installed application (apps). Most of these can be used
immediately. Even the non-activated applications can generally be tested for 50 hours. If a specific
application works well for you, a license can be ordered from Müller-Elektronik to activate the full
version of the application.
The full versions of the following applications are installed on the terminal:
▪
ISOBUS interface (ISOBUS-UT)
The terminal enables you to operate ISOBUS job computers which are ISO 11783 compliant.
The user interfaces for operating a job computer are shown on the terminal screen if this is
connected to the ISOBUS connector of the vehicle.
The ISOBUS interface has no icon of its own. The icon for the connected job computer will
always be displayed in the selection menu.
▪
- Service application.
The Service application allows you to:
– Configure the terminal.
– Enable and disable other applications.
– Enter license activation codes.
– Enable drivers for connected devices.
– Configuration of the GPS settings
▪
- Tractor-ECU application
The Tractor-ECU application is used to record all settings around the tractor.
Here, you can e.g.:
– Enter the position of the GPS receiver.
– Set the GPS receiver as the speed signal source.
– Select which sensor signals are received by the terminal.
– View the speed and PTO shaft rotational speed on the screen.
More about this in section: Tractor-ECU application [
3.4
Full versions
