Basic control principles
Switching on the terminal
5
30322538-02-EN
V9.20191001
19
Basic control principles
Switching on the terminal
To switch on the terminal:
The terminal is installed and connected to the ISOBUS basic vehicle harness.
1.
Press and hold the
button for approx. 3 seconds.
⇨
The terminal will beep briefly.
⇨
The terminal screen remains dark for approx. 10 seconds until the applications are loaded in
the background.
⇨
The Start screen of the terminal appears:
⇨
You have started the terminal.
Initial start-up
The next step to perform after switching on the terminal depends on the purpose of the terminal:
▪
Parallel driving
▪
Operation of ISOBUS implements
▪
Automatic section control
▪
Task management and documentation
These cases will be described in the following sections.
Using the terminal for parallel driving
If you want to use the terminal for parallel driving, TRACK-Leader is the most important app for you.
Most important settings
Setting
Where?
Purpose
Select the GPS driver.
/ Driver / GPS [
The standard driver works in
most cases for the receivers
sold by ME. However, to
change the correction signal, a
fitting driver for the GPS
receiver must be activated.
5
5.1
Procedure
5.2
5.2.1
