Attaching the Mounting Bracket to a Wall
– continued
DEC 2000
3-5
SC
t
300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
Required Tools and Materials
for Concrete Wall Mounting
Do not use toggle bolts in sheet rock (dry wall). They will
not hold the system and they will damage the wall.
CAUTION
Due to the many types of walls that the BTS could potentially be
mounted to, it is impossible to detail all types in the context of this
manual. For this reason, the installers must use good judgement and get
recommendations from qualified personnel regarding the type of
mounting bolts that are appropriate for the particular walls on which the
BTS will be mounted.
Concrete wall
The following tools and materials are required to properly and safely
install the the mounting bracket on a concrete wall.
Table 3-1: Mounting Bracket Tools and Materials for Concrete Wall Mounting
Hand Tools
Materials
Power Tools
T30 Torx tamper bit, 1/4–in hex
metal shim material
Hilti wall drilling rig
Torque driver wrench, 1/4–in hex
female drive, 0–10 N–M
Hilti anchors (for each
bracket)
Hilti DCM 18–14 metric bit
15/16-in. (23.8 mm) socket, a ratchet
wrench, and an 18-in. (45.7 cm)
breaker bar
MicroCell or PicoCell
Mounting Kit
shop vacuum
safety glasses
electrical tape
chalk for marking outline on wall
tape measure
4-ft (1.22 m) bubble level
rubber mallet
ear plugs
dust mask
3
