Remote GPS Head Installation
– continued
PRELIMINARY
SC
t
300 BTS Hardware Installation, ATP and FRU Procedures
DEC 2000
3-22
Table 3-11: Installing the RGPS Head
Step
Action
5
! CAUTION
To avoid binding the RGPS interface cable turn the pipe not the RGPS head while tightening
To avoid binding the RGPS interface cable, turn the pipe, not the RGPS head, while tightening.
Insert the pipe into the threaded neck on the RGPS head and hand tighten.
6
Place the assembly into the mounting brackets and secure with the two clamp brackets, U–bolts
and nuts as shown in Figure 3-9.
Figure 3-9: Installing the Remote GPS Head
WALL MOUNTING
BRACKETS (2)
CLAMP BRACKETS (2)
U–BOLTS
CABLE TO SITE I/O
INTERFACE
REFER TO VIEW A
CABLE TO
SITE I/O
INTERFACE
RGPS HEAD WITH
12 PIN MALE
CONNECTOR
MATING
CONNECTORS
RGPS INTERFACE
CABLE WITH 12 PIN
FEMALE CONNECTOR
ON ONE END AND
UNTERMINATED WIRE
ON OTHER END
VIEW A
RGPS HEAD
(MOTOROLA PART
NUMBER 0186012H03)
3
