Attaching the Mounting Bracket to a Ceiling
– continued
DEC 2000
3-11
SC
t
300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
Securing Mounting Bracket to
Adapter
Once the adapter has been secured to the ceiling, the procedure in
Table 3-5 must be followed to mount the bracket to the adapter.
Table 3-5: Procedure to Secure the Mounting Bracket to the Adapter
Step
Action
1
Verify that isolating pads and bracket–mounted shoulder
washers are installed on the bracket. If not, contact the site
manager.
2
Position the mounting bracket on the ceiling adapter and align
the mounting holes. See Figure 3-4.
3
Use a T30 Torx tamper bit to start but not tighten the M6x19
screws in each mounting hole. Begin with the outer holes and
work toward the center.
4
Use a T30 Torx tamper bit to torque each M6x19 screw to
5 N–M.
Figure 3-4: Securing Mounting Bracket to the Adapter
M6x19 SCREWS
3
